Away Stabilizer
The Canon 10×30 Image Stabilized Binoculars
If you like to watch wildlife from a distance, then you know that you can learn quite a bit about the animal you are observing without them even knowing you are there.. Typically you can learn quite a bit about what you are observing, however there is usualy one small problem with doing this.
If you are using regular binoculars to view wildlife, and you don’t have a stand setup, then the image tends to be a bit shaky and this can be very bothersome and you may not be able to observe very well. The Canon 10×30 Image stabilized binoculars can resolve this problem for you.
The Canon IS binoculars help reduce the natural shaking caused by your hands and allow you to see clearly. I won’t get into how it works in this article, but if you do any activates like bird watching or stargazing, these binoculars will help eliminate almost all the shaking that is caused by your hands leaving you with a crystal clear vision.
You may be wondering what the 10×30 means. Well to put it in simple terms, the 10 means that you can see 10 times the magnification through the binoculars then you could if you were just looking at the image with your naked eye. The 30 is just the measurement across the lens in millimeters, so a 30 millimeter lens is wider then a 25 millimeter lens allowing you to see a wider view.
Using the image stability on these binoculars is easy, all you need to do is press on and hold the IS push button down and let go of it to stop viewing in IS mode. Releasing the IS button turns off the IS feature and allows you to use the binoculars like a normal pair. The Canon 10×30 IS binoculars use 2 AA batteries that usually last about 20 hours with the IS feature on.
The canon 10×30 IS binoculars are great for the passionate birder, stargazer, hunter or anyone who just wants to enjoy nature from far away.
I
About the Author
If you want to see your images clearly without shaking check out the full review of the Canon 10×30 IS binoculars, how they work and where to get them at http://canonisbinoculars.com
how do you fit stabilizers on a childs bike?
hi, my husband purchased a bike for our 2 yr old and assembled it, then threw the box and manual away. He fitted both stabilizers touching the floor at the same time and now the poor baby can’t move because the wheel is suspended in the air and the bike is resting on the stabilizers and of course it won’t move.
Mr Brain is back to work until saturday and my son is getting really frustrated, so I tried everywhere on the internet to see how I can adust the stabilizers, but found nothing. I think they need to be one lower than the other and not touching the floor at the same time, don’t they?
any answer will be much appreciated!
Thanks Parthinia, I tried to view the video, unfortunately they asked me to download some software first, which I have tried, too, but my ocguard blocked it because it was a trojan download. Thanks anyway
Yes only one stabilisers at a time should reach the ground, it sounds to me that they are fitted to low on the frame.
